![]() You can combine (add) up to 4 independent sources and send the result to left and/or right speaker. There is a phase switch for each channel.Īvailable test tone types are: sine wave, square, triangle, saw tooth, white noise, pink noise.Īs you can see on sample images, first source is very basic and thus very easy to use. Second source is more complex and allows sweeping of frequency for sine waves. Third source is quite similar to the previous one except that frequencies are aligned with a musical scale (reference is 440Hz). Rotating knobs are there to ease frequency selection. The display at bottom of first tab is a rough waveform viewer, to monitor the generated signal. The output RMS power of a channel is indicated. Clipping is indicated as well should it occur (sources are added).Īny comment, any feedback ? There is a blog for this. KICKER recommends using these test tones to reach the most accurate and best performing settings. Note that the built-in speaker cannot reproduce the highest and lowest frequencies (below 400 and above 11000Hz to give an idea). Next, slowly turn (clockwise) the gain on the amplifier up until you see the Gain LED light up or hear audible distortion, then turn it down a little. Test tone generator 4 cracked registration#. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |